Zenoah G4100 Manuel du propriétaire

G4100OWNER’S MANUALCHAIN SAW115 40 34-38 (010)GB

GB-10G41006. Sawing GUARD AGAINST KICKBACK • This saw is equipped with a chain brake that will stop the chain in the event of kickback if operating

GB-11G4100GBA log lying on the ground Saw down halfway, then roll the log over and cut from the opposite side. A log hanging off the ground In area A,

GB-12G4100 PERIODICAL SERVICE POINTS 1. Cylinder fins Dust clogging between the cylinder fins will cause overheating of the engine. Periodicall

GB-13G4100GB8. Maintenance of Saw Chain and Guide Bar Saw ChainIt is very important for smooth and safe op-eration to always keep the cutters sharp.T

GB-14G41009. Troubleshooting GuideCase 1. Starting failureMake sure the icing prevention system is not working. 10. Disposal• Whenyou disposeof

GB-15G4100GB11. SpecicationsPower unit: Displacement (cm3): ...

GB-16G4100Limited warrantyShould any failure occur on the product under normal operating conditions within the applicable warranty period, the fa

GB-2G4100EXPLANATION OF SYMBOLS AND SAFETY WARNINGSContents 1. For Safe Operation ...

GB-3G4100GB1. For safe operationWARNINGThis chainsaw has been especially designed for tree maintenance and should therefore only be used by trained op

GB-4G4100(1) cover (2) guide bar(3) saw chain (4) nut20. Operate the chain saw only in well ventilated areas. Never start or run the engine inside a

GB-5G4100GB2. Explanation of Symbols on the MachineFor safe operation and maintenance, symbols are carved in relief on the machine. According to

GB-6G4100Bar protector Guide barSaw chainPlug wrench(Hexagon socket (S13/S19) + Slotted driver)Screwdriver for carburetor adjustment(Slotted driver)Po

GB-7G4100GB4. Fuel and Chain Oil FUEL WARNING• Gasoline is very flammable. Avoid smo king or bringing any flame or sparks near fuel. Make sure

GB-8G41005. When engine has ignited, first push in the choke knob to “START” position and then pull the starter again to start the engine.6.

GB-9G4100GBCarburetor anti-freeze mechanismOperating chain saws in temperatures of 0 – 5°C attimes of high humidity may result in ice formin