Zenoah G260PUM Spécifications télécharger pdf (Page 13)

GREASE THE DRIVESHAFT

Remove the driveshaft by loosening the two

4mm screws from the outer strut housing.

Slide the inner strut assembly with shaft out of

the boat. Wipe away any oil and grease.

Re-grease the shaft using GrimRacer Speed Grease

(AQUB9500). Re-install the shaft and inner strut housing,

making sure the two 4mm screws are tight.

ENGINE MAINTENANCE AND STORAGE

• After a day of running, start your engine and choke it while

it is running to get a lot of fuel into the engine. Run it for

about 30 seconds, constantly choking the engine. Afterwards

it is a good idea to cover the inlet to the carburetor to keep

foreign materials out and moisture from entering the motor.

• For long term (winter) storage it is a good idea to ﬂ ood the

engine as described above as well as coating the inside

of the engine with After Run Oil 2 oz (HCAP3000)

• Before transporting your model, remove all of

the gasoline from the tank and lines and make

sure your oil line shut off clip is locked.

RADIO BOX MAINTENANCE

• When ﬁ nished running, open the radio box and leave the

radio box lid off overnight to allow any water to evaporate.

Remove standing water by pulling out the drain plug and

draining away any water that might have entered the hull.

• Remove and toss out the old batteries.

1 2 ... 8 9 10 11 12 13 14 15 16

Pas de commentaire

Zenoah G260PUM Spécifications Page 13