Zenoah G260PU Manuel de service télécharger pdf (Page 10)

13. Service Guide

1. REMOVING PISTON PIN (Fig.9)

1) Remove snap rings from both sides of the

piston pin.

2) Engage the rod assy(1101-96220) to the

piston pin and gently tap with a plastic

hammer to push out the pin while holding

piston firmly.

Hard hammering may damage the big end of

the connecting rod.

2. INSTALLING PISTON (Fig.10)

1) Make sure to point the arrow mark on the

piston to the exhaust side.

2) Fit the circlip in the groove so as to face the

end gap below.

Deformed circlip may come off during engine

operation and damage the engine.

CAUTION

Fig.9

Fig.10

12. Special Tools

Part Name Part No. External Appearance Usage

1 Puller Assy 1490-96101 To remove rotor.

2 Piston Stopper 4810-96220

3 Rod Assy 1101-96220 To remove/install piston pin.

4 Hex Wrench 3304-97611

5 Snap Ring Pliers 5500-96110 To remove snap ring.

To hold crankshaft when

disassembling/assembling

the rotor.

For socket screw of

4mm, 5mm and 6mm.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15

Pas de commentaire

Zenoah G260PU Manuel de service Page 10